wanna do some armor like ...... storm troopers iron man exe.......was wondering if anyone here did that stuff
Anyone do any 3d printing?
- Thread starter Howiemandel01
- Start date
My engineer friend does 3d printing. He's Gen-X. Yes, I'm jealous.
Make fun of me all you want, but I have been saving up for one of these bad boys for my home office/game room. I already have 2 swords 
armstreet.com
Paladin Knight Armor Kit Etched Stainless
Armor knight paladin medieval SCA armour kit
I used to do 3d printing… I enjoyed the design side of it more than anything else. All my stuff is just collecting dust. i still have to mess with the Gcode and the hot plate on the Z axis is slightly tilted.
The most difficult part is getting consistent prints and being able to adjust/fine tune ur printer as needed.
if you look into the comic-con cosplay world, they use a hard foam material to make these suits. forget what it's called
I want a 3D printed howie mandible(jaw related bc he suqqqqqq) bobble head
how i can tell howie is 57, he used 'exe' in place of 'etc'. 'Et Cetera' but no, it's 'EXEcetrah'. maybe im reading too much into it but i have a beautiful mind like russell crowe
I have an older frend like this who will say errands as 'arrons'. i do have previous experience.
Most of the new 3d printers have automated bed levelers. I am familiar with 3d modeling. Im not good at it. I just know enough to bypass about 8 hours of, what does this button do. lol
My God the man is stunning.
Yes. Yes he is.
Or it might not catch on at all. 3D milling, however, is the effin' bomb!